Iron Craft Challenge #17 – Hardware Coaster

The challenge for the Iron Crafters this time around was to make something using supplies from a hardware store. Here’s what I picked up, o-rings and washers.
Iron Craft Challenge #17 - Hardware Coasters
The o-rings are just those plastic bracelets we all used to wear up our arms in the 80’s (yikes, I’m dating myself). The washers were a steal at $0.79 a pound! I took those pieces and turned them into coasters.
Iron Craft Challenge #17 - Hardware Coasters
I added some cork and Mod Podge Dimensional from the craft store to pull it all together but the main items are those hardware store pieces. I’m not sure the Mod Podge was the way to go here, as is rusted the cheap washers a bit, but it gives a nice finish and seems to hold up to a damp glass so far. If I did this again I would use a plastic resin instead.

Hardware Coasters

Supplies:

  • compass
  • cardstock
  • cork
  • 3 1/2 inch o-rings
  • washers
  • Mod Podge Dimentional (or a plastic resin)
  • exacto knife or scissors

1. Use your compass to draw a circle on the cardstock the same size as your o-rings. It will look neatest when done if the cardstock fits inside the o-ring with none hanging out. Cut out and glue the circle to the cork.
Iron Craft Challenge #17 - Hardware Coasters
2. Glue the o-ring on top of the cardstock.
Iron Craft Challenge #17 - Hardware Coasters
3. Place the washers inside the o-ring.

4. Fill with the Mod Podge or resin. If you get any bubbles a small paint brush can help get them out. Let dry at least over night.
Iron Craft Challenge #17 - Hardware Coasters Iron Craft Challenge #17 - Hardware Coasters
5. Cut the coaster out using the exacto knife or scissors.

If you are not reading this post in a feed reader or at http://justcraftyenough.com then the site you are reading is illegally publishing copyrighted material. Contact us at justcraftyenough AT yahoo DOT COM. All patterns, text and photographs in this post are the original creations & property of the author unless otherwise noted.
© 2005 – 2012 Kathy Lewinski & Susan Cornish
12 years ago by in Challenges , Craft Projects , Crafts , Iron Craft , Projects | You can follow any responses to this entry through the RSS feed. You can leave a response, or trackback from your own site.
3 Comments to Iron Craft Challenge #17 – Hardware Coaster

Leave a Reply to Tabitha
Cancel reply

* Required